Topics

1

General Mach Discussion / Display Spindle load VFD in Mach3?

« on: December 13, 2007, 12:41:53 PM »

Hi,

anyone got an Idea if it's possible to display the analog output signal of my VFD in the mach screen? (Amp measurement of the VFD)
This way you can have a cool "spindle load meter"  on the screen!

regards,
Adryan

2

General Mach Discussion / Contour Shuttle and rel. 2.009

« on: November 13, 2006, 03:20:16 PM »

Hi,

Perhaps it's only with my installation but after updating from 2.003 to 2.009 the feed++ /-- and inner knob of the shuttle pro stoped working.
Do I need to alter some settings for rel. 2.009?

Following I downgraded to rel. 2.003 and everything worked fine again....