Topics

1

General Mach Discussion / LazyCam problems

« on: August 20, 2008, 04:22:14 PM »

Could some one do me a favor and run this DXF through LazyCam for me. I can get good code with a .187 inside offset and with no offset  but I get errors when I try with a .187 outside offset. I would be very grateful.

Steve

2

LazyCam (Beta) / Lcam Confusion

« on: October 12, 2007, 05:16:52 PM »

Can someone open the attached DFX look at it then open it in Lcam and see if there's extra crap in the upper left hand corner.
After that would you try to pocket the lower inside area, I get nothing. I don't understand ether of these problems.

Thanks,
Steve