Hello Guest it is October 14, 2019, 12:54:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - mstinnett

Pages: 1
General Mach Discussion / output question
« on: July 01, 2008, 07:16:33 AM »
Can anyone help me with an output signal question?  How do I configure an output signal that is pulled high or low when the Mach 3 has completed its program.  In other words, it signals a PLC that it has completed its work.  Thanks.


General Mach Discussion / remote start button
« on: June 19, 2008, 07:44:59 AM »
I am new to using Mach 3.  I want to start a program using a remote mechanical start button.  I do not want to press the Start button on the PC.  I am using OEM TRIGGER #1 pin 15 as the input.  I can see it change states on the diagnostic screen.  I do not know how to create a macro or whatever is needed to be called from the main program to look for the trigger to change states and start the program.  Any help would be appreciated.

Pages: 1