Hello Guest it is January 25, 2020, 01:09:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Derek Ryden

Pages: 1
1
Mach3 under Vista / Mach3 under 32 bit Windows 7 (AGAIN!)
« on: June 16, 2015, 06:42:20 AM »
I have been running Mach3 successfully for several years under Windows XP, connected to a small lathe via a box made by Syl. That PC has now died. After reading the various posts on this subject, I got a new PC running Windows 7, 32 bit. Basic problem is that there doesn't appear to be any output to the control box. Mach 3 appears to be working as before. I've run the Driver Test utility and that said everything was OK. Downstream of the parallel port I assume everything is OK (it was fine last week). It just seems that Mach3 isn't talking to the parallel port. Any ideas? One way or another I HAVE to get this thing working!

Pages: 1