1
dspMC/IP Motion Controller / Repeating
« on: March 22, 2010, 03:58:09 AM »
Hi!
Does any of you guys who have been already installed DSPMC controller problem whit repeating of G Code.
I Can make a perefect circle, but I can not repeat it. It is also interesting that I can't put the axis in to the 0.000 position. they always go to the same position as you can see on the picture bellow.
Thanks
Does any of you guys who have been already installed DSPMC controller problem whit repeating of G Code.
I Can make a perefect circle, but I can not repeat it. It is also interesting that I can't put the axis in to the 0.000 position. they always go to the same position as you can see on the picture bellow.
Thanks