Topics

1

General Mach Discussion / Pci express

« on: October 01, 2008, 06:07:27 PM »

just wondering if i would have any problems running a pci express 25 pin serial port?  The new computer only has PCI-e and I can pick up a card for cheap.  THANKS 

2

General Mach Discussion / Possible wrong settings? or hardware?

« on: September 20, 2006, 11:04:38 AM »

I just purchased a new Taig cnc mill with 430 super nema steppers.  I'm using the Xylotex driver for control... so now onto my issue that's either with settings in Mach3 or something in my Xylotex hardware.  When I jog the X axis my Z axis moves along with my A axis (rotary table) and when I jog my Z axis my X and Y axis moves.  Nothing happens when I try to jog my Y and A axis.

I'm new with Mach3 and very green with CNC control so any help would be appriciated.  THANKS!