1
General Mach Discussion / Rogers Encoder board
« on: October 18, 2008, 08:34:25 AM »
I have a Rodger's encoder board installed. It is set for a .010 following error and when the compressor kicks on the board goes into reset and stops my machine. I have taken every precaution in my wiring of the control box to eliminate noise. I have two independently different setups, one with air spindles the other with electric. The Colombo(elec.) runs perfect with no issues. but when the Air turbine spindles call for air and the compressor kicks on, system goes into reset. Any help or direction to a cure would be most appreciated.