1
Mach4 General Discussion / Machine continues to run after MPG stop
« on: August 18, 2018, 06:14:50 PM »
Hello,
I have a handwheel connected via a pokeys56u, when I'm in CONT mode, the axis still moves with the set step.
I can turn my MPG faster than the axle can drive, if I stop turning it still runs "until" she has caught up all the steps.
Can this behavior be stopped?
I liked that the machine stopped immediately when I stop the handwheel.
For info:
I have the latest software from Pokeys.
For step output, I use the ESS, even with the latest software.
Mach4Hobby in the current version.
Greeting Andy
I have a handwheel connected via a pokeys56u, when I'm in CONT mode, the axis still moves with the set step.
I can turn my MPG faster than the axle can drive, if I stop turning it still runs "until" she has caught up all the steps.
Can this behavior be stopped?
I liked that the machine stopped immediately when I stop the handwheel.
For info:
I have the latest software from Pokeys.
For step output, I use the ESS, even with the latest software.
Mach4Hobby in the current version.
Greeting Andy