Hello Guest it is March 28, 2024, 05:54:03 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - snocutt

Pages: 1
1
General Mach Discussion / cnc router work
« on: August 19, 2008, 02:28:24 PM »
I'm looking to have small carbon composite parts trimmed, 2 different designs they're about 9x10x1.5 cm overall and the material thickness is 1mm. It would be an initial run of 30-40 pairs.

http://i298.photobucket.com/albums/mm274/snocutt/assem01.jpg

http://i298.photobucket.com/albums/mm274/snocutt/assem02.jpg

2
General Mach Discussion / 3 dimmensional trim path
« on: May 23, 2008, 08:06:34 AM »
I'm completely new, never touched a cnc machine. I'll be getting a starter cnc router, it would be from moosecreeksales on ebay. The job I'm looking to accomplish is trimming small fiberglass parts that have a 3d trim path, the bit can stay vertical. My question is, what would roughly be involved in programming a 3d path? I have a solid model of the part and can read the profile manualy. Unless there's an easier automated way to go from a solid model.

Pages: 1