1
General Mach Discussion / disabled steppers after a period of inactivity??
« on: May 08, 2008, 03:52:30 AM »
Hi guys, I'm new to this game and have run into a minor set up problem that I'd really like to resolve before continuing the setup of my first basic mill. I started using KCam because it seemed to be a good choice for a beginner, but after being a little disappointed with its performance gave Mach3 a test run, well there's just no comparison, I was a little afraid of all the bells and whistles in Mach3, but taking it one step at a time I'm starting to work things out.
Now in KCam I used pin 14 as an output to my controllers to enable my steppers, and after a period of inactivity I think it was five seconds they would be disabled to help avoid overheating of the stepper motors, can Mach3 do this I can't seem to work out how??
Any help is greatly appreciated,
Darren.
Now in KCam I used pin 14 as an output to my controllers to enable my steppers, and after a period of inactivity I think it was five seconds they would be disabled to help avoid overheating of the stepper motors, can Mach3 do this I can't seem to work out how??
Any help is greatly appreciated,
Darren.