Topics

1

General Mach Discussion / Mach3 error message! Help!!!!

« on: April 08, 2017, 07:58:19 PM »

I'm sure I did this when I was playing around with brains, macros, etc. But I don't have a clue what I did.

That directory the error message references doesn't exist.  I've reinstalled mach3 and have gone back to the original screen set.  It didn't help a bit. 

Any ideas of what's going on?

Thanks

Sent from my SM-P900 using Tapatalk

2

General Mach Discussion / Tool Auto Zero Script

« on: March 18, 2017, 09:57:41 PM »

OK, I know there is probably an easy answer for this.  And I have searched but have been unable to find one. 

I added a single jack to my machine so I could plug my probe & touch plate in as needed.  My problem is the probe is a Normally Close function and the touch plate is a Normally Open function.  Now I suppose I could just go to "Ports & Pins" config and change the probe input from Active High to Active Low as needed.  But there's got to be a more elegant solution.

I'm pretty sure I can't modify G31 so does anyone know of a Auto Tool Zero script that doesn't use G31?  Something I could modify so the touch test condition from Active to Not Active.  What have other people done? 

Thanks