Topics

1

Newfangled Solutions Mach3 Wizards / V2.81 for Tormach?

« on: December 07, 2008, 12:36:39 PM »

Ron,

Will you be releasing a version for the Tormach?

Mike

2

Forum suggestions and report forum problems. / Mark all sections read?

« on: November 03, 2007, 02:23:06 PM »

I know that each section can be marked as read, but is there a way to do that for all sections at once?

If not, would it be hard to add the feature?

Mike

3

Forum suggestions and report forum problems. / Log-in not retained

« on: July 28, 2007, 04:23:44 PM »

For a few weeks now, the forum has been refusing to "remember" so that I have to manually log in each time I visit.  Is there a setting in IE 7 that needs to be adjusted somewhere?

Mike

4

Forum suggestions and report forum problems. / Server bandwidth problems?

« on: March 02, 2007, 10:14:24 PM »

Several times during the past week when trying to access the forum I've gotten a message to the effect that the server bandwidth has been exceeded.  Is this a known problem or am I the only one having it?

Mike

5

General Mach Discussion / Mach3 vs Mach2 - benefits

« on: December 15, 2006, 11:44:11 PM »

Is there a link to a page that describes the differences between Mach2 and Mach3?

I have a Tormach mill which uses Mach2 and am wondering what upgrading to Mach3 might get me.

Mike