Guest
Show Posts
1
Third party software and hardware support forums. / PCI Parallel card NetMos added not reconized...
« on: February 19, 2007, 05:13:18 PM »
Hi !
I added a pci card to get 2 more parallel ports and drive more switches.. I bought a netmos and added it in the pc.. it is reconized by xp as lpt2/lpt3...
When I configure it in mach3, I don't see anything... I checked "use 2nd port", changes and tried all the possible adresses and nothing happens...
I used the little application "port finder" and it sees the 3 ports with the right adresses : 378,278, 3BC..
I don't know what to do now...
Any Idea ?
I must say that I downloaded ComTools to tes the ports... Lpt1 is tested correctly... but LPT2 and LPT3 not... they are PNP in the system config...
Does anyone knows something about adding Netmos card ?
I added a pci card to get 2 more parallel ports and drive more switches.. I bought a netmos and added it in the pc.. it is reconized by xp as lpt2/lpt3...
When I configure it in mach3, I don't see anything... I checked "use 2nd port", changes and tried all the possible adresses and nothing happens...
I used the little application "port finder" and it sees the 3 ports with the right adresses : 378,278, 3BC..
I don't know what to do now...
Any Idea ?
I must say that I downloaded ComTools to tes the ports... Lpt1 is tested correctly... but LPT2 and LPT3 not... they are PNP in the system config...
Does anyone knows something about adding Netmos card ?