1
General Mach Discussion / Big Tex screen set
« on: December 08, 2016, 02:10:43 AM »
Hi All,
I have problem with new installed Mach3 and Big Tex Screen set. Once i Hit Z plate offset, the probing doing good, but after touch finished, the Z going down straight again(only can stop it with hit reset/stop button) Any one have solution about this?
I used previous version(few year ago version) with no problem, the old pc was damage and i have install everything new,now face this problem.
Best Regards,
Hawk
I have problem with new installed Mach3 and Big Tex Screen set. Once i Hit Z plate offset, the probing doing good, but after touch finished, the Z going down straight again(only can stop it with hit reset/stop button) Any one have solution about this?
I used previous version(few year ago version) with no problem, the old pc was damage and i have install everything new,now face this problem.
Best Regards,
Hawk