Hello Guest it is September 19, 2019, 05:14:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Fawaad

Pages: 1
1
General Mach Discussion / PID In MACIV
« on: August 27, 2006, 12:33:13 PM »
Hi,
   I am basically an embedded system programmer and currently working on developing a Driver module for Step and Direction based DC Servo Motor control system. I wanted to know if MACIV has built in implementation of PID control loop for DC Servo Motors or do i need to implement it in the Driver Module.
   

Pages: 1