Hello Guest it is July 21, 2019, 01:26:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Edmund

Pages: 1
1
General Mach Discussion / Program crash
« on: May 02, 2019, 02:19:27 PM »
Running XP stand alone version R3.043.066 everything has gone haywire and status window says cannot reverse run from present feedhold

Can any member give me a clue

2
General Mach Discussion / Need Help re: download
« on: October 25, 2009, 07:22:28 PM »
Mach3 into old computer,

Mitra clone (I think?), 133 megahertz, Pentium 1 (Ithink), Windows 98 second edition,4.10.2222A, 40MB RAM,

I tried downloading Mach3 R3.042.029, no good unable too, I'm not a wizz at computers, my question is, if I download windows XP (if I can?) will that enable me to load Mach3?,

I have Master5 loaded at this moment,

..................Edmund...............

3
LazyCam (Beta) / problem with lazycam
« on: October 22, 2009, 12:03:16 AM »
sending a drawing in dxf autocad 2000

Pages: 1