Guest
Show Posts
1
General Mach Discussion / Post order?
« on: April 12, 2008, 08:03:47 PM »
Art,
Thanks very much for everything you've done for the CNC community at large, and thanks so much for this sub-forum to help newbies like myself. My only suggestion is that you number your thread titles in the order in which they should be read.. Otherwise I see your wisdom on choices but they may be based on decisions you covered elsewhere. If they differ from the route I'm taking, it'd be unwise for me to follow without fully understanding the why's behind those decisions. If I could approach them in the order you approached them in, I might have a better reference point.
I'm constantly torn by router table home build descriptions, versus motor specs, versus drivers, versus linear motion systems, versus what people are getting out of their machines versus how much I can spend.
My biggest problem seems to be understanding enough about everything involved to be able to estimate it's compatibility..
Thanks very much for everything you've done for the CNC community at large, and thanks so much for this sub-forum to help newbies like myself. My only suggestion is that you number your thread titles in the order in which they should be read.. Otherwise I see your wisdom on choices but they may be based on decisions you covered elsewhere. If they differ from the route I'm taking, it'd be unwise for me to follow without fully understanding the why's behind those decisions. If I could approach them in the order you approached them in, I might have a better reference point.
I'm constantly torn by router table home build descriptions, versus motor specs, versus drivers, versus linear motion systems, versus what people are getting out of their machines versus how much I can spend.
My biggest problem seems to be understanding enough about everything involved to be able to estimate it's compatibility..