Hello Guest it is March 28, 2024, 06:25:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - arqarod

Pages: 1
1
General Mach Discussion / emergency mode forever
« on: August 23, 2006, 10:26:35 AM »
Trying to learn mach3 i have 2 pc, run ok in the first one, but i have a problem in the other, the reset button flashs and says the emergency mode is active.
Tryed to unmark the estop sign in the config/port&pins/input signals window, but not a solution.
maybe a limits problem, my cnc device is not conected to the pc, and in a confcheck its all ok exept this:
/////////Motor Settings - Enabled Motors only are Checked/////////////////////!.

 A motor Step pin is set to a port other than 1 or 2, this is probably an error..
 A motor Direction pin is set to a port other than 1 or 2, this is probably an error..
 A motor Step pin is set to a port other than 1 or 2, this is probably an error..
 A motor Direction pin is set to a port other than 1 or 2, this is probably an error..
 A motor Step pin is set to a port other than 1 or 2, this is probably an error..
 A motor Direction pin is set to a port other than 1 or 2, this is probably an error..

how can i desactivate the emergency mode?
please help.

Pages: 1