1
General Mach Discussion / Bad printer test results
« on: September 14, 2008, 09:57:01 PM »
Receiving bad printer testes results even after disabling all unnecessary services. Have tried 3 MB so far and all have the same result.
Getting proficient in Installing system on different MB's and running thru the optimisation. txt but port seems to be silent and without reason I get a wave that looks like a big fat hairy caterpillar and then goes silent again , have tried to run the alternate drive but the system blue screens on me.
Thinking that maybe this is an error if there isn't a breakout board connect yet , but should have one PMDX 132 in about two weeks time.
Only popup that I cannot seem to disable is the message that the updates have been disable but they are ??
Initially thought it might be the registration but thats been down now
Getting proficient in Installing system on different MB's and running thru the optimisation. txt but port seems to be silent and without reason I get a wave that looks like a big fat hairy caterpillar and then goes silent again , have tried to run the alternate drive but the system blue screens on me.
Thinking that maybe this is an error if there isn't a breakout board connect yet , but should have one PMDX 132 in about two weeks time.
Only popup that I cannot seem to disable is the message that the updates have been disable but they are ??
Initially thought it might be the registration but thats been down now