1
General Mach Discussion / Tracing eye and mach
« on: August 15, 2006, 03:21:10 AM »
I've been given a Burny 3 controller with a tracing eye(and gantry,motors, gear boxes, and drives). I want to run M3 with a MP-1000-THC and gecko's. I'm wondering how I could hook this up so the eye could teach mach a part.
Will I need to keep the burny?
If I need to keep the burny how do I hook up 2 different drives?
What cheap THC options are there that will allow me to just run the burny?
Idealy I would like to run just M3 with an eye and skid the burny control.
Help!!!!!
Will I need to keep the burny?
If I need to keep the burny how do I hook up 2 different drives?
What cheap THC options are there that will allow me to just run the burny?
Idealy I would like to run just M3 with an eye and skid the burny control.
Help!!!!!