Hello Guest it is October 26, 2020, 05:59:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nerginer

Pages: 1
1
Hi,
This is Nuri from MakerStorage LLC.
I need your help on Determining the velocity of an axis near real-time with brains (or maybe with vb script) with Mach3
I want to send this information via Modbus. I know the Modbus part but need help on getting the current velocity of one axis.
Thanks for your help

Regards,
Nuri
www.makerstorage.com

2
Promote and discuss your product / Mach3 as 3d printer software
« on: October 25, 2010, 02:58:50 AM »
Hi,
I am a big fun of mach3. I decided to use mach3 for my homemade 3d printer like reprap or makerbot. I use an arduino for the extruder temperature control. A host software is messaging over usb (serial rs232). mach3 is controlling the 4D system via gcode. I have a problem. The serial communication has a negative effect on mach3.
the motors did not work smooth when I plug the usb.

Please send me your advice to correct this issue.

Regards,
Nuri Erginer

3
General Mach Discussion / estop chargepump
« on: January 14, 2010, 03:50:49 AM »
Hi,
I need an output signal (hi/low not chargepump) when estop button pressed and released
is it possible in mach3

regards,
Nuri Erginer

4
General Mach Discussion / wireless mach
« on: August 08, 2006, 10:25:08 AM »
Did any body use such a device to use mach wireless

http://www.trendnet.com/en/products/TEW-P1PG.htm

Pages: 1