1
General Mach Discussion / Setting up mach3
« on: March 18, 2008, 10:18:46 AM »
Hello. I have four little six wired step motors with these M109 modules and M108 interface switch to connect them to printer port in motherboard (0x378 i suppose). There came small program with the modules that i can run motors with just fine but i havent got Mach3 working yet.
http://www.kemo-electronic.de/en/module/m109/index.htm
http://www.kemo-electronic.com/en/module/m108/index.htm
Here is picture of my ports and pins section. I have disabled e-stop but it didnt help.
Is there some larger tutorial that would contain information about each and every setting?
http://www.kemo-electronic.de/en/module/m109/index.htm
http://www.kemo-electronic.com/en/module/m108/index.htm
Here is picture of my ports and pins section. I have disabled e-stop but it didnt help.
Is there some larger tutorial that would contain information about each and every setting?