Hello Guest it is January 20, 2021, 08:25:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - arboleda4

Pages: 1
1
General Mach Discussion / Fit a MPG to lathe and mill
« on: April 15, 2010, 12:23:28 PM »
Is it possible to fit an a MPG to a Wabeco mill and lathe through Mach3

2
General Mach Discussion / Spindle speed hunts
« on: April 10, 2010, 10:18:50 AM »
Set speed to 4000 rpm but machine goes up to 5000 rpm and then backs off to 4000 rpm and is ok then till you change speed again and the same happens

3
General Mach Discussion / D6000E spindle speed
« on: April 06, 2010, 12:53:25 PM »
Hi
Problems with spindle control
Set at 500 rpm but when running it shows a true speed of -80 (minus) It is running at 500 on Tacho
Set at 1000 "    "    "   "   "    "    "     "     "     "      "  -97   "    "  It is running at 733 on Tacho
The only speed which is stable is 500
Anyone know what I am doing wrong

4
General Mach Discussion / Mill spindle safety switch
« on: January 04, 2009, 11:07:57 AM »
Hi
I am making a new spindle with a Dandrea quick change system for my Wabeco CC-F1410 LF high speed spindle mill.
At the same time I will fit a manual spindle lock . The problem I have is finding some way to stop the spindle from switching on when the lock is in place.
I need to know where to wire the micro switch which will be fitted to the lock pin so the spindle will not be able to power up either in cnc or manual mode.
Maybe disable the cnc mode altogether.

Dave


5
General Mach Discussion / Spindle revs out of control
« on: December 18, 2008, 04:36:49 PM »
Need Help
My wabeco lathe spindle goes max speed no matter what i set it at.
before this happened it was going about 500 revs above programed and after a few seconds would go to programed speed

Dave

6
General Mach Discussion / Spindle not turning
« on: November 30, 2008, 04:48:38 PM »
Hi all
got a problem. My wabeco lathe wont turn the chuck . Works ok in manual and the axis works in cnc but no spindle
although the the spindle led is lit it must think it is on.
Any ideas
Dave

7
General Mach Discussion / switching from cnc to manual
« on: November 13, 2008, 05:41:13 PM »
Hi all

Have a big problem with both my Wabeco lathe and mill
Its ok on cnc mode but have to keep switching back and forth to get into manual mode.
Takes forever to switch to manual. Any ideas

Dave

8
General Mach Discussion / manual feedrate override pot
« on: November 10, 2008, 04:56:44 AM »
Hi all
I am new to this forum and would like some help with fitting feed override (pots) to my Wabeco mill and lathe.
I dont like the mouse one on the monitor and prefer a manual one.

Pick your brains please

Dave

Pages: 1