Hello Guest it is March 29, 2024, 07:44:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jlautomatio

Pages: 1
1
LazyCam (Beta) / lazycam need info on dxf files
« on: November 06, 2007, 09:17:21 PM »
my question is this if i hahe rectange box with corner with arc the problem is when i cut with mach3 it cut the line ccw  and the arc it cut some time ccw or cw and dont follow the line the z go up and down 

2
General Mach Discussion / mach3 repeat info
« on: September 15, 2007, 07:00:08 PM »
i made nc file with meshcam from stl file my question is this could i repeat the same file 2 or 4 or more with x or y offset and then the cnc stop a other way to ask is if my file is 2x2 and the pice of wood is 2.5 x 12 so my file will be repeat 6 time and stop to change the peice of wood thank you jacques

3
LazyCam (Beta) / inf lazycam 2.64 mach3 rc2.0.g
« on: October 04, 2006, 10:01:11 AM »
need info on new upload
my problem is when i generate g code with lazycam it generate like this
c:\mach3\gcodef09.nc
it should be
c:\mach3\gcode\f09.nc

4
LazyCam (Beta) / lazycam
« on: June 17, 2006, 09:57:44 AM »
Question
with ver 1 no problem
with vewr 2.53
i am using milling and wiht setup in lazycam
when the milling bit go down it ok but when it go up the z move in same time with x an y this is a problem and do the have a way to set up all the layer control an keep for next dxt

Pages: 1