1
General Mach Discussion / Thinking of buying Mach3
« on: July 22, 2006, 11:25:19 PM »
HI Everyone,
I am considering of getting mach3 to controll a homemade cnc router/engraver and I have a question.
Do I need encoders on the stepper motors to let the mach3 know whats going on?
I plan on using a driver board from hobbycnc and was wondering if this would be suitable? I am new at cnc.
Any comments are appreciated. Regards Charlie
I am considering of getting mach3 to controll a homemade cnc router/engraver and I have a question.
Do I need encoders on the stepper motors to let the mach3 know whats going on?
I plan on using a driver board from hobbycnc and was wondering if this would be suitable? I am new at cnc.
Any comments are appreciated. Regards Charlie