1
General Mach Discussion / mach don't control the spindle switch
« on: March 26, 2008, 11:18:07 AM »
u can see the setings atached.
i tried a lpt tester program and the switch works on pin 8 so the problem is with the mach setings.
also tried lots of diffrent setings , i installed a diffrent version of mach.. nothing happens.
in the "diagnostics" tab the "output 1" is blinking red when i input "m3" command.
i tried a lpt tester program and the switch works on pin 8 so the problem is with the mach setings.
also tried lots of diffrent setings , i installed a diffrent version of mach.. nothing happens.
in the "diagnostics" tab the "output 1" is blinking red when i input "m3" command.