Topics

1

Newfangled Solutions Mach3 Wizards / Write Wizard - No code output

« on: July 21, 2006, 10:41:58 PM »

Can some one give me a crash course on using it?  Can't get it to output any code at all.  Must not have something set correctly.

William in MN

2

General Mach Discussion / Upgrade - now dead!

« on: July 16, 2006, 05:15:42 PM »

 

I don't understand.  All I did was upgrade to the latest and greatest, and now the little bugger sits motionless.  As I started to explain on a post I found regarding the topic, I got an error "No Driver sensed installed."  "Run Driver test."  That sounds good to me, so I opened up the folder where everything is saved, and try and run the driver test.  The same error message is displayed.  So, I try and install the new 1.90 software in its own folder...great new screen layout!  Same error when installing.  Only this time it won't allow me to even run the Driver Test.  Click the button and nothing...

Please help,  It 'twas working hours ago, but not anymore.

Regards,

William in MN