Hello Guest it is May 07, 2021, 07:01:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dighsx

Pages: 1
1
General Mach Discussion / Pulse Frequency Slow down
« on: July 15, 2006, 04:11:20 PM »
I've got a strange one here.  I'll be running Mach3 and then out of the blue the Pulse Frequency will drop to 100 and the machine stops (well it's moving be very very very slowly).  If I then close the program and bring it back up things run fine for a while.  Normally my Pulse Frequency is around 25353 and stays pretty steady.  My Time to Int jumps around from about 8 to 11. 

The other thing that's odd is if I bring up Mach3 and just let it sit there (no machine or controllers on) after a while it'll do drop to 100. 

So I figured it was the computer, I made sure nothing else was running and it still did it.  Then I loaded Mach3 onto a faster computer (2ghz P4) and just let Mach3 sit there and it did the same thing? 

I'm stumped.



Take it easy,
Jay

Pages: 1