Hello Guest it is March 28, 2024, 10:39:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Vince Endter

Pages: 1
1
Brains Development / User DRO?
« on: May 13, 2008, 04:27:45 PM »
I need a way to pass a signal from Mach to cubloc for the collet closer.  I think I need a user DRO.  I need to make a couple buttons in screen 4 and have them open and close the collet closer.  I looked throug the WIKI and did not see what number I should use.  Any suggestions? I know how to use the brain to send the signal to the cubloc (thanks everybody).  I just need to know what to put into the buttons.

Thanks

Vince

2
Brains Development / Cubloc, brains and ModIO
« on: April 05, 2008, 12:06:25 PM »
I am going to try to use a Cubloc to control the tool turret on a CHNC lathe.  I would like to know how I can sent the tool requested information from Mach to the Cubloc via ModIO.  I guess a brain would work, but how does one get the tool number from mach to modio?

Thanks

Vince

3
Show"N"Tell ( Your Machines) / Hardinge CHNC
« on: March 29, 2008, 01:45:04 PM »
I started with a CHNC that was literally full of rocks, dirt and sand and I just got the X and Z axis moving.  I have been keeping a log of the project here:

http://www.cnczone.com/forums/showthread.php?t=50685

Vince

Pages: 1