Hello Guest it is April 26, 2024, 01:03:57 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - BWP

Pages: 1
1
General Mach Discussion / Spindle start up problem
« on: August 08, 2008, 03:13:23 PM »
About a week ago I had a couple glitches with the spindle starting and then stopping for a few seconds and then it would continue to run and then stay running. Today I went to start the machine,  I get movement with my X,Yand Z axis's but the spindle wont start. The machine ran yesterday without a problem for 4-5 hrs. continuous.

2
General Mach Discussion / Parts are being cut smaller than the gcode #s
« on: February 14, 2008, 02:15:53 PM »
Hello Mach Users,  I am new to cnc, and just learning my way around Mach3. I drew some parts in Autocad and sent them to the machine and after the parts were cut they varied in sizes. A cut that was supposed to finish out at 12' measured  11.948, the next cut was supposed to finish out at 39.125 and finished at 39.0625 (appx.) and a parts that was to finish out at 46.625, finished at 46.5 appx. Can someone please help me with this problem ? The machines motors are tuned to have 1917.812366 steps per inch, if that helps.

Pages: 1