Hello Guest it is March 28, 2024, 12:25:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jeff8451

Pages: 1
1
G-Code, CAD, and CAM discussions / difining a axis
« on: June 21, 2008, 11:45:31 AM »
I am needing to define a axis to straighten a bore on a horizontal mill. Can someone direct me through this process of defining a axis and getting it into the g code.

2
General Mach Discussion / Re: PCI port card addressing woes
« on: February 04, 2008, 05:46:03 AM »
I worked on mine again today, I am still baffled.
Q? Did you hook up your lp2 card to a device first? Is your enable plug and play device checked on? Did you manually set your card to lpt2? mine comes up as lpt3, but i change it. My lowest hexidecimal address is in the programs, acc, sys tool, sys info, hardware, i/O area: And it is E080-E08f. but in device manager it says ec00. Is my card not compatible????? Have you tried the   other cards you purchased? ty for the help.

I am checking my pins for voltage change with enable1,2,3.

I get no change at all. 17 is at low voltage and 2-9, 14,16 are 5.10. It must be an addressing issue. i think I am going to hook it up to a scanner, or printer next.

3
General Mach Discussion / Re: PCI port card addressing woes
« on: January 31, 2008, 09:00:11 PM »
I am using the same 9835 netmos pci card, and it wont work for me, the drivers are the same for all metmos cards 9835, 9735 ect? this card worked with my 3k system that started missing. with 2k the address came up as 278m what address did you use? the multifunction card address or the plt2,3 address?

4
General Mach Discussion / Re: PCI port card addressing woes
« on: January 29, 2008, 08:13:22 PM »
It is only 59 bucks, and they just told me no charge if they cant fix it

5
General Mach Discussion / Re: PCI port card addressing woes
« on: January 29, 2008, 08:09:09 PM »
Ok, Someone with a retail version of windows needs to contact Microsoft for support. Not the OEM version. I think it has something to do with the way Windows detects the M.B. MY 1G dual pIII just bit the bit. I want my 2nd port working again

 I have got two address numbers: one for multifunction I/O EC00. and one for parrallel port I/O E800. That cant be good????
I bet it can be fixed in the registry????? Just a guess, but Microsoft needs to fix us up. 866 234 2060.

6
I have the same problem now. I have lpt3 netmos card. My address is different tho. E800- E807, And it is constantly set to ECP,

I am hooking up this to turn on hydraulic motor; to control spindle lock and gear selection.

I was wondering if you got this figured out?

I am also wondering if it would be best to use the enable, or output leds? does it matter?

I also am have trouble getting the 6 axis stuff in mach 3 2.00.

I also wish I could find examble VBscript on new buttons that would turn on one led and turn off another.

Any help would be greatly appriciated. ty jeff8451@sbcglobal.net

Pages: 1