Hello Guest it is April 21, 2021, 02:41:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tipit

Pages: 1 2 3 »
1
General Mach Discussion / Re: Mach3 and Windows 7
« on: January 15, 2016, 12:50:43 AM »
Thank you for the screen shots info, always better to have more than to be sorry

2
General Mach Discussion / Re: Mach3 and Windows 7
« on: January 13, 2016, 01:55:11 PM »
Thank you for the info

I will copy the entire folder, just in case

3
General Mach Discussion / Mach3 and Windows 7
« on: January 12, 2016, 10:43:35 PM »
Hi to all of you

I am now using Mach3 with Windows XP, Can't get any  update for XP anymore and some off other software that is  on the same PC are starting to stop running. Will Mach3 work with Win 7 both OS are 32 Bits, if so,  what should I save  from Mach3 and how to do this.

Thank you.

4
General Mach Discussion / Re: New PlugIn just about done..
« on: April 19, 2013, 11:32:45 PM »
Thank you for your help.
The screws that wasn't visible where under the rubber feet,remove those and it comes apart, the trouble seem to be where the wire enter the shuttle.
I was using it with an extension of 6feet, while I was at it I change the original wire for a 14 feet, now it's working like the first day I bought it and further more no extension.

5
General Mach Discussion / Re: New PlugIn just about done..
« on: April 17, 2013, 05:42:17 PM »
Hi,
I have try to open it and it gust do not want to open, any special way to do this.
Thank you

6
General Mach Discussion / Re: New PlugIn just about done..
« on: March 19, 2013, 12:35:40 AM »
Hi to every one
I have been reading just about every post on this tread and couldn't find a solution for my problem which is that my shuttle pro2 suddenly stop now and then.
Sometime it will work for hours and other time it's up for 5 minutes and out it goes.
I'm using Mach3 Ver. 3.042 040 on Win XP
Thank you

7
General Mach Discussion / Re: UPGRADING MACH VERSION
« on: December 21, 2011, 08:53:36 PM »
Thank you for the info

8
General Mach Discussion / UPGRADING MACH VERSION
« on: December 21, 2011, 07:14:50 PM »
Hi,
A couple of stupid questions, maybe that is why my search didn't came up with anything.

If I upgrade Mach Version will I lose all my setting, can I copy my MachMill.xml file from the older version to the newer version, in other words what should I do to avoid loosing my set up?
Thank you

9
PROBLEM RESOLVE

10
Hi,
Rich before jumping to conclusion you should ask some question, do you think you are exclusive.
Thank you Ger21 for your support, like you mention asking for somebody to send me the software plus serial isn't the right way to do this, but like I mention I have already paid for it and can prove it and Rich the programmer mention that the upgrades are free; I have sent a few Email To Rich with no replies.

I need the software for my rotary axis

Pages: 1 2 3 »