Hello Guest it is March 23, 2023, 11:08:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LJJ

Pages: 1
1
I am trying to build a collection of all post processors for many CAM programs.
I was hoping if you had any I could use, you could upload them to this thread.
I will then host then in the new section here http://www.machsupport.com/cam.htm

Thanks for your help.


Benny



I have seup Sprut Cam 4.0 with Mach 3. I'm not an expert, so you may want to verify all the paramaters first, but It is working for me with my 3 axis mill and mach 3/Quantum.

Pages: 1