Messages

1

General Mach Discussion / motor settings and xyz limits cnc9000

« on: January 14, 2008, 08:37:59 AM »

anyone familiar with the CNC9000 from Circuit Specialist Inc, if so any suggestions on motor tuning?
Is there a way to set X,Y,Z limits using machine coordinates if I do not have limit switches installed?

Very new user

2

LazyCam (Beta) / Re: L-cam post Gcode not working

« on: January 11, 2008, 07:22:49 AM »

Brett,
Thanks forthe reply.  I have reinstalled M3 and LC.  I can bring a dxf into LC and then post code successfully.  I can even add text and post gcode.  But when I try offset or pocketing it seems to preform the operations in LC but will not post gcode.  It is as if pocketing and offset does not work, and after attempting these operation the file is corrupted and you need start over.  It is a shame these operations do not work.  I know LC is free with M3 but these are two very important operations and LC does not seem very useful without these even if it is free.

3

LazyCam (Beta) / L-cam post Gcode not working

« on: January 10, 2008, 01:07:40 PM »

First time user.
Recently purchased Mach3 and add-ons.  The "Using Mach3 Mill" pdf manual shows a file import DXF directly into Mach3 I can not find this import option section 6.7.  I have version R3.01.  Also Lazy Cam does not Post Gcode after the first time.  I can open a DXF and Post Gcode to Mach3, then when I make changes in Lazy Cam or close and reopen and try to post again it indicates that the file has been written but it does not exist and does not load into Mach3.  I have searched the Forums but have not found an answer.