Hello Guest it is March 29, 2024, 02:09:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GoFaster

Pages: 1
1
If the parallel port connector attaches to the motherboard via a ribbon cable and the connector is not keyed,make sure it's not plugged in backwards.  Also ensure the BIOS setting for the motherboard is set to ECP+EPP.  HTH.

- Felix

2
General Mach Discussion / Re: R3.00 Auto Limit Override?
« on: January 09, 2008, 05:00:42 PM »
Thank you! I found it and the Override Limits selection in the Settings screen.
Have to work out some issues with the CNC4PC breakout board bit otherwise the system is running great!

3
General Mach Discussion / R3.00 Auto Limit Override?
« on: January 09, 2008, 10:02:57 AM »
Hi -

I'm a new Mach3 user (version R3.00).  I've been setting up limit/home switches on my X2 mill - when I jog to a limit and trip the switch, motion stops as expected.  However I can't jog off the switch.  There is supposed to be a "Auto Limit Override" checkbox in the General Config page but for the life of me, I can't find it.  Can I get a clue please?  :)


Pages: 1