1
General Mach Discussion / HMI
« on: June 25, 2009, 11:01:03 AM »
Hello:
Has anyone looked into using a HMI such a Baijer E-100 for a panel or pendent? It uses RS232 or RS422 protocol. I have no idea if Mach can communicate with one or not. Can one communicate to Mach3 through the serial port? I know you can use modbus and I saw that some ware in the E-100 literature that it could use modbus. An HMI can do lots of things and I'm hoping it can speak Mach3. I'm not a very good wire head just a good machinist.
Thanks
Jack Adams
Has anyone looked into using a HMI such a Baijer E-100 for a panel or pendent? It uses RS232 or RS422 protocol. I have no idea if Mach can communicate with one or not. Can one communicate to Mach3 through the serial port? I know you can use modbus and I saw that some ware in the E-100 literature that it could use modbus. An HMI can do lots of things and I'm hoping it can speak Mach3. I'm not a very good wire head just a good machinist.
Thanks
Jack Adams