Hello Guest it is February 07, 2023, 06:19:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - puckee

Pages: 1
1
General Mach Discussion / Re: gcodes
« on: January 03, 2008, 02:30:56 PM »
Ok the parts are maple and taking a cut on the x axis from left to right  handle first as  the tool moves from handle to barrel it cuts less wood
I need to speed the feed up to maintain the same tool pressure, the part wants to move excessivy, The lathe I uses is home made a cincinatti tray top converted with a ball screw.  The spindle rpm are not tied to the software, I have no dro,  I made a follow rest with a tool to pre cut the dowel as the part turns, in order to use it I must be able to adjust the speeds to maintain tool pressure......

Thanks for your help

Tom
Puckee

2
General Mach Discussion / Re: gcodes
« on: January 02, 2008, 07:49:21 PM »
thanks for the responses  We do have very large crickets in OK "USA"


I own a small Bat business  Infinity Bats,

Up to now I have been using cnc pro a dos based program


ok so if i am running at 15ipm without effecting the rpm I cannot change the speed liniear IE enter a new speed and over the 7 inches of travel the x axix ramps up to the new speed.



3
General Mach Discussion / gcodes
« on: January 02, 2008, 12:07:58 AM »
hello and happy new year i am new to the post and hope someone can help I am interested in ramping the feed rate over a distsance  rather than stair stepping the changes
I would like it to be smooth any ideas are appreciated  PS this is for a lathe profiling bats

Pages: 1