Messages

1

General Mach Discussion / Re: Mach 3 controller not responding after?

« on: January 03, 2008, 10:37:11 PM »

Thank you, will try it and see what happens.

2

General Mach Discussion / Mach 3 controller not responding after?

« on: January 01, 2008, 10:07:16 PM »

Hello and let me say it's nice to see so many thinkers out there. I have been running Mach 3 first version and updated to the lastest and noticed that after a rebot the following morning it would not respond / the table would not move. So I have a spare backup computer and I switch over to check with the older version and it worked perfectly. So I checked the config and everything matched up, so I had to completely remove the install and reinstall the older version. Running Windows XP with  3ghz processor. Any thoughts??