Hello Guest it is December 09, 2021, 03:28:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PerE

Pages: 1 2 »
1
Modbus / Re: ModIO dimensions
« on: December 30, 2007, 04:36:40 AM »
Hello Hood.
It is about 15mm without the plastic spacers.
Best regards: Per

2
LazyCam (Beta) / Re: lead in outs
« on: November 21, 2007, 04:48:15 AM »
Hi.
I have also problem with the G41. Lcam generate some very strange code with small reverse movement over the desired lines so when i cut it cuts over my lines and back again. It is a very simple rektangel.
I will try it more today and coming back with the results but i have been struggling with this for a couple of days now.
Best regards.
Per
Here is the picture from Mach3 2.60

3
General Mach Discussion / Re: Modio for inputs/outputs only - No motors.....
« on: September 26, 2007, 04:23:29 AM »
Send me a mail at "per.ekdahl at comhem.se" then i send you the manual.
Cheers.
Per

4
General Mach Discussion / Fang Gamepad for Mach3
« on: September 14, 2007, 05:28:02 AM »
Hello.
Has anybody tried to use Fang gamepad with Mach3 and does anybody know whats inside the gamepad, processor etc ?
Per

5
General Mach Discussion / Re: Pendant/control panel with PIC 18f4221.
« on: August 08, 2007, 07:20:04 AM »
Thanks for the replies. I have purchased a WISP628 and i have already started to program the unit.  ;)
Per

6
General Mach Discussion / Re: Pendant/control panel with PIC 18f4221.
« on: August 06, 2007, 04:11:27 AM »
Thank you but i already have my processor (PIC 18F4221) and i want to program that one for my application.
I want to learn ASM (assembler) and i want to build my own pendant/control panel.
Per

7
General Mach Discussion / Pendant/control panel with PIC 18f4221.
« on: August 05, 2007, 06:57:17 AM »
Hello all.
I want to build my own pendant/control panel for my router and i am going to use a PIC 18f4221 microcontroller. I want to learn to program this unit and use it for controll Mach3. Has anybody done this and what are the hints ? What do i have to think about when i am doing this ? Be gentle to me because it´s hard to learn an old dog (46year) to sit.  ;)
Per

8
General Mach Discussion / Re: Best way to connect a pendant to pc ?
« on: July 11, 2007, 04:40:05 AM »
So that means that i cant hacking a keyboard to use it with keygrabber. I was planning to switch my keyboard to USB and then use an old PS2 keyboard with keygrabber.
Per

9
General Mach Discussion / Re: Best way to connect a pendant to pc ?
« on: July 07, 2007, 11:53:55 AM »
Thank you for your replies. I got in the right direktion now  ;)
Per

10
General Mach Discussion / Best way to connect a pendant to pc ?
« on: July 06, 2007, 04:49:51 AM »
Hi all.
I have started to build an pendant and what ports are best for keygrabber, PS2 or USB ?
My MPG is connected to the parallel port but the rest must go thru keygrabber.
Best regards.
Per

Pages: 1 2 »