Hello Guest it is March 28, 2024, 10:42:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wintech1

Pages: 1
1
Yes, this is good, I put the code needed to start the mill and a way it goes.

Thanks,
Steve

2
General Mach Discussion / Cycle Start - Input Signals or an OME Code
« on: June 07, 2006, 07:28:07 PM »
I'm trying to use a start switch instead of going to the Key pad to start the mill, I have got an Estop working but having a little trouble with the Cycle Start.

Thanks
Steve

Pages: 1