Messages

1

LazyCam (Beta) / Cut order

« on: July 04, 2006, 09:12:16 PM »

I was wondering is there was a way to change the cut order in LazyCam, I went back and watched the video of LazyCam in the vid section and Art said that could change them but didnt show an example.  I have some files that ( im guessing now) the orders that the chains was drawn that the order of cuts ia all over the place.  If I could change the order of the cuts then could reduce a lot of rapid time and reduce the overall cut time.

Tim Cobb

2

Mach3 and G-Rex / Grex and THC

« on: June 07, 2006, 07:36:18 AM »

I am in the process of designing and building a Plasma table. My question is , does the Grex support a THC and if not now would it be possable in the near future?

Tim Cobb