Hello Guest it is March 28, 2024, 10:20:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kabol

Pages: 1
1
FAQs / Re: new computer
« on: March 17, 2011, 03:37:53 PM »
I've also seen the holes in the female connector be off shape and not make good contact. Also when checking continuity between pins wiggle the cable near each connector to check for intermittent connections.

                                 Kabol

2
General Mach Discussion / Re: semi circle problems
« on: March 12, 2011, 05:36:13 PM »
Thanks! I think you solved my problem also.

        Kabol

3
FAQs / Re: new computer
« on: February 08, 2011, 08:14:41 PM »
Nice thread! It answered my question also.

Thanks
  Kabol

4
Share Your GCode / Re: Square & Compass
« on: January 03, 2010, 10:11:51 PM »
Fantastic site.
        Thanks
              CK

5
VB and the development of wizards / Re: Help with a simple VB script
« on: December 20, 2007, 05:02:25 PM »
The biggest hording in programming is the fear to try to straightforward approve.

6
I would like the plans or tap files also.
Thanks.

7
Fantastic job!  Very few things impress me but you succeeded with this.

Kabol


8
General Mach Discussion / Re: gcode to mill half ball with cnc mill
« on: December 19, 2007, 04:59:08 PM »
I’ve been watching this thread on and off for a few days and I wish to thank both Stirling & Cameraman for a very informative thread. I’m just learning CNC so this project was a huge help to me.

Kabol

Pages: 1