Guest
Show Posts
1
General Mach Discussion / Resets, Reboots, etc
« on: June 01, 2006, 06:39:30 PM »
Hello all.
Help please.
I have trouble with my computer crashing, rebooting, etc. Yeah, I know I need a better computer, but for the meantime I have this problem:
Whenever it does this (or basically, whenever the RESET blinks and I click on it), I have to re-zero all axis.
Is there a way to keep this information stored so I can shut down my computer nightly, thus avoiding most of the crashes? Once I spend an hour to set up the machine (I need +/- 0.005 maximum 0.002 would be better), I tend to leave it alone so I don't have to deal with it. After a while, it crashes, then I have to re-center my chuck.
Let me be clear: the axis do not go to 0.0000, but rather some random number (usually about 25 mils off what I want). I don't know where these numbers came from.
Thanks ahead of time...
Help please.
I have trouble with my computer crashing, rebooting, etc. Yeah, I know I need a better computer, but for the meantime I have this problem:
Whenever it does this (or basically, whenever the RESET blinks and I click on it), I have to re-zero all axis.
Is there a way to keep this information stored so I can shut down my computer nightly, thus avoiding most of the crashes? Once I spend an hour to set up the machine (I need +/- 0.005 maximum 0.002 would be better), I tend to leave it alone so I don't have to deal with it. After a while, it crashes, then I have to re-center my chuck.
Let me be clear: the axis do not go to 0.0000, but rather some random number (usually about 25 mils off what I want). I don't know where these numbers came from.
Thanks ahead of time...