Hello Guest it is March 28, 2024, 06:28:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bird-shots

Pages: 1
1
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 22, 2007, 09:45:36 AM »
I count 2,500,000 plus or minus 500k

2
General Mach Discussion / Re: Bit for drilling soft aluminum
« on: May 27, 2006, 12:53:05 PM »
Will do, thanks...geach

3
General Mach Discussion / Re: Bit for drilling soft aluminum
« on: May 27, 2006, 11:59:26 AM »
Thanks Brian, I'll give it a try. Do you have a particular bit in mind...end mill, 'V', etc...TiN, carbide, etc...straight, spiral, etc...single flute, double flute, etc ? I searched the Internet for a week and the only thing I've found is an article by some of the Guhring guys...good article but a little too high tech for me.

Thanks again,

geach

4
General Mach Discussion / Bit for drilling soft aluminum
« on: May 26, 2006, 09:57:55 PM »
My project is simple, I'm drilling a dozen 1/8" holes in 6063 aluminum flat stock 1/8" thick.  Does anyone have a recommendation for a bit and/or technique that will minimize gumming?

geach

Pages: 1