Hello Guest it is October 20, 2019, 09:07:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cliveastro

Pages: 1 2 3 4 5 6 7 8 »
1
Thanks Rich

I must admit I have not played with Mach for a couple of years and the memory fades.

Clive

2
Rich
I started by asking for the details from the seller, but like a lot of the people they are just box shifters and they dont have any information or cant be bothered to get it.
I have trawled around the other sellers and they dont appear to have any information either.

As this is going to have a 4th axis are there any keyboard commands for the A axis, I know X Y and Z.



Regards

Clive

4
Hi
I have just got my tb6560 4 axis controller working with Mach 3 despite the instructions.
With it I bought a little blue hand controller that plugs in and is meant to act as a pendant, this does not work.
Two questions really the first, are there any settings in Mach 3 to turn it on?
Also it has a miniature USB connector on it, does this need to be powered (there is 5 volts on the board).
I can find no information anywhere about this controller not even a pin out.

Regards

Clive

5
GearoticMotion Preliminary testing / Re: Gearotica testing
« on: July 30, 2010, 01:59:51 PM »
I also found the text very difficult to read

6
GearoticMotion Preliminary testing / Re: Gearotica testing
« on: July 29, 2010, 02:24:20 PM »
Had mostly the same problems as Rich no project button slider didnt work in involute.
This was with a socket 939 mboard with Amd 4200 dual and a Fire XL graphics card.

7
General Mach Discussion / Re: Turn Eccentric Wizard
« on: March 31, 2010, 03:31:08 PM »
Having thought about it for a bit, that ony gives you an offset arc not an eccentric circle!!

8
General Mach Discussion / Re: Turn Eccentric Wizard
« on: March 31, 2010, 03:26:26 PM »
Thats a very good idea Graham, but I was only being lazy.
I seem to speed ages setting up 4 jaw chucks

Clive

9
General Mach Discussion / Re: Turn Eccentric Wizard
« on: March 31, 2010, 02:46:19 PM »
I did too.

10
General Mach Discussion / Re: Turn Eccentric Wizard
« on: March 31, 2010, 12:13:16 PM »
Very Good point I will definately stick to 4 jaw chuck

Clive

Pages: 1 2 3 4 5 6 7 8 »