Messages

1

General Mach Discussion / Re: Setting up Mach3 to drive Stepmaster controller

« on: September 12, 2008, 10:21:10 PM »

Thanks! After re-reading the manual & some interpolation (I thank God for this!), I was able to get the router to move. I also had some direction problems. Thanx again!!

2

General Mach Discussion / Setting up Mach3 to drive Stepmaster controller

« on: September 11, 2008, 10:19:04 PM »

Need help with setting up Mach3 to drive Stepmaster controller. It worked correctly at one time, however I can't seem to find the right 'switch' to cause the controller to move the motors. I have read the documentation and watched the videos ( many times!). I believe I am missing something very elementary. Please help.

3

General Mach Discussion / Re: Calling all post processors. ( Help me to help you )

« on: November 20, 2007, 05:36:17 PM »

Does anyone have the post processor for StepMaster NC TM? Thanx!