1
General Mach Discussion / Dumb question from a Newby !
« on: March 07, 2008, 07:31:06 PM »
OK Guys !
I know this is a dumb question!
While running a program sometimes I notice that the cutter is cutting a bit deep (or shallow).
Is there a way to pause the run and adjust the Z depth, then resume running.
I have tried 'Feed Hold' and then jogging the z, but when i resume running the program it just goes back to the original depth.
Any Ideas ?
fred in winder, ga
I know this is a dumb question!
While running a program sometimes I notice that the cutter is cutting a bit deep (or shallow).
Is there a way to pause the run and adjust the Z depth, then resume running.
I have tried 'Feed Hold' and then jogging the z, but when i resume running the program it just goes back to the original depth.
Any Ideas ?
fred in winder, ga