Hello Guest it is March 29, 2024, 02:53:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gbecerra

Pages: 1
1
LazyCam (Beta) / Re: Limited to 50 lines
« on: November 07, 2007, 11:43:00 PM »

If I buy the LazyCam Pro will this eliminate the limited 50 lines  of the trial version?



2
LazyCam (Beta) / Re: Limited to 50 lines
« on: November 07, 2007, 04:41:04 PM »
Where can I get the file MachLic.data-file?


Thanks

Giby's

3
G-Code, CAD, and CAM discussions / LazyCam=>MACH 3 need help
« on: November 07, 2007, 03:14:28 PM »
Hello
My problem is that I can only import 50 cutting points to MACH 3 from LazyCam. When I export the DXF file into LazyCam the cutting path shows correctly but when I export the LazyCam File (G-Code) into MACH 3 it shows incomplete. The pattern I have found is that I can only export 50 cutting points in to Mach 3. So, cutting paths greater than 50 points are not exported into MACH 3.

The version of I am using is MACH 3 R2.48 demo version.

I need help tracing this problem? I don't know if it is LazyCam or MACH 3 related?

Thank You in advance for your help.

4
General Mach Discussion / LazyCam=>Mach 3 Need help
« on: November 07, 2007, 03:12:29 PM »
Hello
My problem is that I can only import 50 cutting points to MACH 3 from LazyCam. When I export the DXF file into LazyCam the cutting path shows correctly but when I export the LazyCam File (G-Code) into MACH 3 it shows incomplete. The pattern I have found is that I can only export 50 cutting points in to Mach 3. So, cutting paths greater than 50 points are not exported into MACH 3.

The version of I am using is MACH 3 R2.48 demo version.

I need help tracing this problem? I don't know if it is LazyCam or MACH 3 related?

Thank You in advance for your help.

Pages: 1