1
Galil / Re: Mesa card plugin
« on: October 05, 2010, 01:53:30 PM »
I'm a long time Mach3 user and was communicating with Mike Walace about using my 7i43 to act as a step direction to PWM converter to run a high power servo amp. He suggested I look here. I have a 7i43, SCSI cables and breakout panels, Jon Elson's high current PWM AMP, servo motor and power supply that I was going to use to test this concept. This solution is much more elegant. I would be happy to help you test but I don't have it connected to my mill which is currently running 3 G320's. I'll lurk and volunteer if I see an opportunity to help. I really need 160 volts @ 20 Amp's to run my mill properly.
Roger
Roger