Hello Guest it is April 19, 2021, 12:49:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mwb

Pages: 1
1
Mach3 under Vista / Re: Ver. 3 full screen
« on: September 11, 2009, 10:23:20 AM »
Thanks all!  The high res did the trick.  Thanks
Mark

2
Mach3 under Vista / Ver. 3 full screen
« on: September 10, 2009, 02:51:08 PM »
The latest version of Mach3 running on Vista will not display full screen.  I've tried on an XP platform and it
displays it fine.  Anyone else experience this ?

3
General Mach Discussion / Problem with MDI at startup
« on: May 11, 2006, 12:09:10 PM »
When I first start up Mach 3 mill I have a problem with the MDI.  After homing the machine I enter an
absolute position using G90, but I get no response.  If I enter a G01 to any position it will move as
requested.  After the G01 command, the G90 will respond, however it moves at feed rate and not
rapid.  Thanks for any help.
Mark

Pages: 1